An embedded automation programmer goes home and fixes appliances for the village elderly for free. 1) Rice cooker: the light flashing on the repair socket means a loose connection, just push it in firmly; boil water to test the response, water temperature rising from 35°C, heating ring at 100-plus, one done. 2) Hair dryer: no response from the switch, so the switch is suspect; two screws out, it has been opened before and the switch tied with string; multimeter on continuity, the switch pressed shows no continuity; the switch clip is broken, inside is a copper leaf + latch + spring, the two contacts on the copper leaf are burnt, and a diode is wired in for the speed change; no such switch on hand, so the burnt parts of the contacts are cleaned and it goes back, fixed with strong glue instead of string; gear one and two latch fine; the original soldering was sloppy — joints must be solid or they arc, and an arc at the grip is dangerous; suggest a varistor in series across the switch input / output; powered up, back to full health. 3) Cordless drill battery bay won’t charge: odd screws, swap the bit; barely charges and the gauge drops on one press, most likely the cells need replacing; 5S, 21V at full charge; when removing the BMS mind the 4 balance leads; clean off the old nickel, keep the holder; originally 1500mAh each, replaced with 5 new 2000mAh cells with 3C certification; measure every cell’s internal resistance before fitting, this batch all around 17mΩ, fine for a Li-ion drill’s power needs; the original had no fish paper but a ring is best, the 18650 shorts most easily right at that ring; in series order, spot-weld the series nickel strips first, then the main + and − strips, last the balance leads; refit the BMS, tin with the iron and solder the balance-lead nickel strips to the board, connect the main + and − last; check for cold joints; fish paper back on, into the battery bay, screws in; the red charge light is normal, the drill pulls hard. 4) Two membrane keyboards merged into one: swap the cable, note the wire order and numbers, the membrane contacts must line up with the board and be pressed with the clamp bar, cable into its slot, add heat-shrink. 5) Hair dryer plug with one long and one short pin: fit a rice-cooker cord, high power so tin the joints to avoid heating, wrap in tape and heat-shrink. Sign-off: night view of the mountain hollow, ‘maybe I can’t make my hometown rich, but I can contribute a little with what I’ve learned’. 260 comments: five cells out of your own pocket, don’t do this kind of job again (3) → creator: lost my shirt; suggest more close-ups (screws, soldering, multimeter readings) → noted; hold the iron by the grip (proper practice); serving the people, down to earth; that workbench is my dream → I’ll make one.